[herbvfr705f]

the install was very easy i would say a 1. It is all self described. When you pull the cover it was difficult not to rip the gasket but it is better to replace it. The installation itself was very simple just make sure you match the first friction plate correctly cause that one is a smaller diameter. The rest is just friction plate steel plate frinction plate steel plate. this also gives you a chance to check out the puilse generator and also your starter reduction gear whick in my case was bad. it was worn on one side pretty bad. So i had a hard time starting my bike. But very very very i repeat very simple. I could do it with my eyes clothes.