Bleeding brakes 6th gen

Discussion in '6th Generation 2002-2013' started by olivino, May 9, 2008.

  1. olivino

    olivino New Member

    Joined:
    Jun 19, 2007
    Messages:
    93
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    New York
    Has anyone bled there own brakes on 6th Gen? I read that for linked brakes one needs a special (and expensive) vacuum tool and should therefore have a dealer do this. I mention this because I see an air bubble in the MC window hole - but the brakes feel fine.
     
  2. two4one

    two4one New Member

    Country:
    United States
    Joined:
    May 25, 2007
    Messages:
    504
    Likes Received:
    5
    Trophy Points:
    33
    Location:
    Mohrsville, PA
    Map
    The bubble is relatively normal. I see it on a like of new bikes.

    As for bleeding, easy as pie. I use a MityVac. You can find these at most automotive stores. Not sure what you read concerning an "expensive" bleeding tool. Do the front then do the rear same as any bike so I've found. Others may disagree but that's my process and I'm sticking to it :)

    Mityvac
     

Share This Page