Gear shift indicator failed / check engine light

Discussion in '7th Generation 2010-Present' started by deklund, Oct 14, 2014.

  1. deklund

    deklund New Member

    Joined:
    Jun 25, 2010
    Messages:
    32
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    So. Cal
    Gear shift indicator failed / check engine light
    So I was just running an errand and on the way home looked down and saw no gear position indicated (manual not DCT bike) and a check engine light on. I just had the bike service recently, so I'm wondering if the lads didn't tighten something correctly when they put it back together. I'm seeing a flickering neutral light no matter what gear I'm in now. I do have the mod plug for the throttle nanny installed, but I can imagine that is causing the neutral light to come on.

    Has anyone else seen this?

    Don
     
    deklund, Oct 14, 2014
    #1
  2. Tpoppa

    Tpoppa New Member

    Country:
    United States
    Joined:
    Apr 20, 2009
    Messages:
    77
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    44130
    Map
    I would disconnect the mod and see if the problem goes away. Either the gear position sensor is bad, or there's an issue along the connection between it and ECM...that is where the mod is located.
     
    Last edited: Oct 15, 2014
    Tpoppa, Oct 15, 2014
    #2
  3. deklund

    deklund New Member

    Joined:
    Jun 25, 2010
    Messages:
    32
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    So. Cal
    Mod caused the problems

    So my mod plug went bad and caused the problem. It could be that it got hot, but there is no obvious reason why it failed.





     
    deklund, Oct 31, 2014
    #3

Share This Page