carlgustav
Last Activity:
Oct 12, 2017
Joined:
Jan 23, 2008
Messages:
313
Likes Received:
7
Trophy Points:
33
Media:
28
Albums:
3
Location:
Heart of Dixie

Share This Page

carlgustav United States

Active Member, from Heart of Dixie

carlgustav was last seen:
Oct 12, 2017
    1. carlgustav
      carlgustav
      Hello,

      I hope you see this response b/c I've not responded from here before. Anyway, installation is very straightforward but describing it is not. The sliders came with a couple of xtra long bolts that replace existing frame bolts. If you have a shop manual (highly recommended budget allowing) there is a good picture on pg. 2-25 of the lt. side of the frame. There are 2 bolts, one goes to the seat rail, and the other to the engine. I removed the bolt to the engine and attached the lt. slider there. There is also a picture of the rt. side of the frame on the same page (top). You can see 2 bolts again, one to the seat rail, the other to the engine just above the rt. crankcase cover. I replaced the bolt just above the crankcase cover with the rt. slider/long bolt unit.

      You may be able to see this in my pix above if you look closely :^).

      Anders
    2. AW1966
      AW1966
      Hi,


      I saw your post in the VFR Forum about the LighTech Frame Sliders for Honda VFR800. I called OPP for instructions as to how to install them, and they said, it will not come with any instructions. Could you help or show me how these sliders are install? Is it hard to install?

      I have a 2007 VFR800.

      Any help is appreciated.
      AW
  • Loading...
  • Loading...
  • About

    Location:
    Heart of Dixie
    Home Country:
    United States

    Signature

    Guns don't kill people, drivers with Cellphones do; author unknown
    '84 VF700F WIP, '07 VFR street sport tour, '02 Aprilia RSV1000 hooligan, '01 XR650R track/street/trail, '05 R6 track
  • Loading...
  • Loading...