Silicon pipe - wrap it around the brackets
I measured mine off the stand abt 700 mm from the top of the forknut to the axle center
I think It is called discrimination or profiling ...
I think this would differ based on your spring (age / after market length etc)
Good luck and welcome aboard the mad house :)
I have still get the rpm needle realigned. It is off by 300 rpm. My OCD wants to get it fixed. thanks Anik
Mounted the new gauges with integrated voltmeter I think my rpm needle is slightly off. Would need dismantle it all over again [IMG] thanks Anik
Nice ride...looks quite clean thanks Anik
Wd40 will work. To make it more effective you should take the switch off the handle bar and spray inside too.
Some more thoughts... remove the screws first to see how far behind the needle goes. Once that is marked screw it back and proceed as above....
Looks earlier PC with k&n sticker
Please, More pictures of the colorful bike
Was wondering if you remove the stop tab first, to see where the needles stop and then take it out... Would work ??
That is what I thought. Was thinking if there is space under the pointer, then to make a marking on the needle sticking out. May give a relative...
How did you manage to align the needles to zero...or did you just push them in ?
OK the images to some time to load. Thanks
Can't see the images on the first post. Good writeup. I just got these faceplates and planning to do the same. Also going to add a miniature...
i have used the 8SMD LED T10 from ebay...removed the housing and flattened the wiring...
yes it would work if connected to the signals. Not done that out of choice
You can read more about it at vfrdiscussion (Acrylic Mirror Extenders - with LED's - VFR Discussion)
Separate names with a comma.