Believe me the difference is huge. The starter needed a lot more power to crank the engine before and in fact , when left outside sometimes it was...
...............YES..... the problem is now fixed. Few years later i solved it. Last winter it started getting cold and i was parking the bike...
Seems its the master cylinder. I have put a new fluid and it has helped a bit, hopefully it will keep up until the rebuild kit arrives :)
Ok , so i started the season around February. Around June i was in a heavy traffic and was clutch slipping and rearbraking between cars. At some...
Its unlikely for the bike to go directly to the same settings as 98 one. There is no engieering logic. If you have problems with O2 it can be a...
No, never fixed it. Injectors were tested, but not on a bench there is only one place here in my country that does this and they charge too much,...
I know :) I recently changed mine. Check here. My bike is black, so im using it directly. Keep in mind the stock plastic where the bolts mount is...
Could be indeed. That is one thing i haven't fully tested, because when i fixed the line the vibration at high vacuum was gone, so i decided it...
Ok made the check with thinning the oil by cranking, but it didn't make huge difference, so its not compression related. Pump does over 5bar of...
Some news on this issue. Yesterday I decided to spray some ether in the intake and see , if it makes any difference. Well, the bike started 1st...
I have a question regarding the fuel filter on this bike. Does anyone know the size of the hoses that connect to it, are tehy 6mm or 8mm. I am...
This was tested of course, also in previous posts i mentioned that fuel pump is already tested and is working fine. It holds steady pressure, also...
Bad news here, everything from sensor side is intact. Resistance on sensors is correct depending on the temperature and also no problem with the...
10x Greg. That will help, i see the graphs there, so for the sensors the expected resistance should be around 4Kohm. I see also the pinouts in...
I was expecting the same, in case of a problem with a sensor, usually the failsafe value for temperature sensors in -40degree Celsius. Still i...
Not much progress, still hard start, when cold. Fuel pressure is good. Today it was 6C and it started from 5th run. Anyone know, what should be...
Previous engine went, because of the small stock oil cooler. I have made a topic here, on that issue and the details are there, if anyone is...
Yes, i tried opening it a bit, but it didn't help. I will try opening it a bit more to see, if this will make any change.
Here is a short video of a cold start. Bike was in a garage and it was 14 C inside. As you can see it needed 3 runs on the starter. Before the...
I will make a video, in the next days to show the exact behavior. But overall staring is now worse after starter valves adjustment. I own the bike...
Separate names with a comma.