Really that's it? Alright I'll try that. I just need the damn thing to start
The carbs were synced last fall. I took them off now just to open the float bowls and clear the jets. Didn't touch anything else. Does a sync need...
Use a bench sync for a throttle stop? Maybe I'm not saying the right thing. I mean the small screw/knob on the left side that's on a cable that...
Bike wasn't starting so I took apart the carbs to clean them. Along the way the throttle stop screw was reset. I need to do a test fire to see if...
Dirty idle jets eh? Would it still idle fine until I increased the throttle? Where is the idle mixture screw? I already had to increase the...
Well the choke isn't the real concern, it starts just fine and choke works when I start it. Just that I noticed if the choke is on and it's idling...
So quite recently my bike (95 vfr) has been stumbling bad when trying to accelerate from a stop. When it's cold it works perfect, once warmed up...
Thanks guys, the bolt worked perfect
Can I use this bolt to hang a small L bracket? The bracket is only a few mm thick. Not sure if the end of that bolt has an impact on the steering...
Alright so test ride was a success. Last time I took the baffle out it surged like crazy and constant backfiring/burbling even while cruising it...
Sorry for the long delay. I finally had some time to look at the bike and the mixture screws are slotted, I bought the pro motion 90° driver and I...
After a run with the exhaust baffle back in, the burbling and popping was dramatically reduced and the surging was reduced by about 50% I'd say....
Yes the kit came with the d shaped tool. I wonder if I caused the issue by removing the exhaust baffle. I thought it was rich so I removed the...
To further add he used a jet and kit and followed the instructions as per the kit. The kit is from 6sigma. It says to use the 132.5 on the front,...
Needles are stock but have been adjusted, the pilot Jets are 42 if that helps. I believe he did not rip or tear anything and installed everything...
So at highway speeds at 4-6 k rpm I don't notice surging, probably because I'm in 6th, but in low gears I notice it most under 5k and it lessens...
Jet size is 130/132.5. elevation here is sea level so I suppose that's fine. The surging is very annoying though. I'll see what the range of the...
Bought a '95 vfr with 30k km on it. It's so clean but having some issues with the carbs. It surges a lot, I generally cruise in town around 4k rpm...
That's pretty grungy looking. The weather has been pretty terrible here for the last month and I've only been out a handful of times. I did get...
Well thanks for the help with what to check for the clutch, I'll check the master cylinder too. I pumped out the old stuff and put new fluid in...
Separate names with a comma.