[ATTACH][ATTACH][ATTACH][ATTACH]Hi guys.. just parked a first gen vfr next to my 4th gen in the garage.. deal I could not pass up.. missing a left...
Sounds like the R/R ... I just installed a Mosfet from Roadstercycles.com..There is a test for the r/r from pin to pin and mine had burned out...
[ATTACH] this is the kit pre soldered and for 10 dollars more well worth it and again it is Roadstercycles.com
All you need for this is a soldering iron.. no tapping into the harness..there could be an issue with the harness itself so this is a direct route...
this was the kit i installed, he offer videos and even in person instruction if you are having issues...
I was having some issues with mine as well in the same area and replaced my R/R with a Mosfet from Roadstercycle.com, the guy builds the kit to...
I installed an Hrc Jet kit on my 1995 VFR..also the K&N, and with those i removed the baffle from my StayInTune Pipe and the snorkel from the...
yes, purchased from Amazon...returning for refund tomorrow do to the junk status:( big waste of time
Someone suggested running a jumper wire from the ground to the neg terminal and a hot fused to the pos terminal spliced right from the output of...
from the new one im getting nothing attached or not, the old one seems to have a short inside that is activated when it touches the frame..the new...
Hanging Regulator So i was at a loss for the charging issue with all checks good ,new reg and all, still no charge at the battery at all with...
I just remounted the old reg/rec back up and there was zero charge rate again...so i unmounted it and let it hang off the bike and it charges?...
Well i tested the Stator output ,good, the battery is new, i bought a replacement reg/rec and was not getting any charge to the battery and for...
Reg/Rec heat? After a few minutes of running to warm up should the reg/rec be very hot to touch if its brand new?
I just unplugged the fan and fired it up, the clamp on the red wire from the reg to the relay was reading maybe 40-50?Sound right? and the reg...
[ATTACH]This fan is the only acc i have and it it wired to the tail light...And how much current should be flowing from the reg to the relay?
im thinking of unraveling the covering on the harness to inspect every wire inch by inch, otherwise i see zero evidence of burnt or melted wires,...
My battery is good and brand new,always tendered..How do i test the starter relay? How do i know if a plug is toasted,there is no visable signs of...
I have checked my stator AC output and it is good, battery is new and reg/rec is new but the voltage on the battery stays at 12.4 volts at idle...
The battery is new and is at 13.3 volts before its started..
Separate names with a comma.