Do i need a power commander if i do lasers?

Discussion in 'Mechanics Garage' started by flyinsc1, May 27, 2008.

  1. flyinsc1

    flyinsc1 New Member

    Joined:
    May 25, 2008
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    If I install a set of the laser pipes on my vfr , do I need to do some sort of power commander to richen the fule mix up. On my cbr I had to install new jets for the carbs, but unsure about the fuel injected system . Thanks, Mike.
     
    flyinsc1, May 27, 2008


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. mello dude

    mello dude Administrator

    Country:
    Italy
    Joined:
    Jan 3, 2006
    Messages:
    4,401
    Likes Received:
    455
    Trophy Points:
    113
    Location:
    Southwest Ohio
    Map
    Assuming you have a 6th gen or even a 5th, no you dont need a PC, but most go that way eventually, it smooths out the power band enuff to notice the difference.

    MD
     
    mello dude, May 27, 2008


    This site may contain affiliate links for which VFRworld may be compensated
    #2
  3. flyinsc1

    flyinsc1 New Member

    Joined:
    May 25, 2008
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Yes , sorry forgot to state that it is a 04 . Thanks. Can you change to vtec engagement point with a power commander or another tuning moduel?
     
    flyinsc1, May 27, 2008


    This site may contain affiliate links for which VFRworld may be compensated
    #3
  4. mello dude

    mello dude Administrator

    Country:
    Italy
    Joined:
    Jan 3, 2006
    Messages:
    4,401
    Likes Received:
    455
    Trophy Points:
    113
    Location:
    Southwest Ohio
    Map
    I havent heard any way to change the vtec engagement point. A good thread on 6th gen mods is posted as the lead off story on the home page.
    Check it out for some good info too.

    MD
     
    mello dude, May 27, 2008


    This site may contain affiliate links for which VFRworld may be compensated
    #4

Share This Page