Really that's it? Alright I'll try that. I just need the damn thing to start
The carbs were synced last fall. I took them off now just to open the float bowls and clear the jets. Didn't touch anything else. Does a sync need...
Use a bench sync for a throttle stop? Maybe I'm not saying the right thing. I mean the small screw/knob on the left side that's on a cable that...
Bike wasn't starting so I took apart the carbs to clean them. Along the way the throttle stop screw was reset. I need to do a test fire to see if...
Dirty idle jets eh? Would it still idle fine until I increased the throttle? Where is the idle mixture screw? I already had to increase the...
Well the choke isn't the real concern, it starts just fine and choke works when I start it. Just that I noticed if the choke is on and it's idling...
So quite recently my bike (95 vfr) has been stumbling bad when trying to accelerate from a stop. When it's cold it works perfect, once warmed up...
Thanks guys, the bolt worked perfect
Can I use this bolt to hang a small L bracket? The bracket is only a few mm thick. Not sure if the end of that bolt has an impact on the steering...
Alright so test ride was a success. Last time I took the baffle out it surged like crazy and constant backfiring/burbling even while cruising it...
Sorry for the long delay. I finally had some time to look at the bike and the mixture screws are slotted, I bought the pro motion 90° driver and I...
After a run with the exhaust baffle back in, the burbling and popping was dramatically reduced and the surging was reduced by about 50% I'd say....
Separate names with a comma.
