Fixed by bleeding clutch lines properly!
Just replaced the clutch springs and radial bearing, getting low power and no stalling upon letting go of the clutch lever.[MEDIA]
Pic of oil used
Update new springs new radial bearing and new oil. Clutch is slipping and will not fully engage the trans when the lever is let out.
Going to get It running, then it's going up on the market.
It's my first bike picked it up last year and was just able to start riding this year, had it safetied and that costed 1700$ then a leak in the...
Upon inspection of the oil I noticed lots of metal shavings... drained oil and took the cover off and found the clutch radial bearing was broke....
Took the slave and cover off and it appears the push rod is as far as it can go, thus the reason the slave cylinder isn't being pushed back... any...
I had a leak in the master cylinder that was fixed trying to get the clutch back working. Noticing a rock hard lever when bled fully, took the...
I'm unsure, I attached a photo looks a bit off too me, it moves out when I squeeze the lever.
Took the slave off
That is the sight glass that was replaced on the master cyclinder that caused the loss of fluid in the first place
When bleeding I get the right amount of pressure but as soon as I close the bleed valve on the slave the lever gets too much pressure and is hard
The clutch doesnt function at all
Got to work and my clutch gave out, checked the master and was out of fluid, found the leak in the sight glass and replaced it, bled the old fluid...
Separate names with a comma.
