All that plastic stuff for motorcycles is VERY hard to find. I hate plastic parts.
No idea what the swing arm is. It has been modified.
Check these out. One has an all polished engine. [IMG] [IMG]
I need a 1984 CDI box for a vf1000F Interceptor. There are two boxes and I need the one that has (7 WIRES) I have the five wire box. They are...
1ZIPLOCK2.... I really do not think you should do this repair yourself. It's OK we can't be everything.
You don't need a carb rebuild kit . It is NOT LIKE A CAR!! Just get a new float needle and install that, and make sure you can see daylight...
I agree. Once a pilot jet (.038) hole is clogged you will be forced to take the float bowl off and get the jet and blow thru it until you see...
When you say SECOND GENERATION, is that years ,models or certain engine or VIN numbers?
Yes...Sally mae walks like she has oil wells in her back yard, but she never complains bout the times be'n hard.
It is not all or nothing. Sometimes the float levels can be off from rubber tip debris clogging up, and float level can be low.
`You do not need to rebuild the carbs. Just remove the float bowl and instal a new needle jet and make sure the idle jet is not clogged from...
I think you are right - get the right tools and take the time to learn to do it YOURSELF. Also after the first valve adjustment it usually does...
Yes a loose tappet is not too much of a problem ( a little noise is all). But a tight valve will not come up far enough to dissipate the heat into...
I COMPLETELY agree!! INSANE costs!!! Think about that before you buy your next vehicle. YES removing the cams to get to the shims is nuts. My...
Would those cam oiling issues be mitigated by modern synthetic oils? I know a machinist who told me recently that if he chucks a piece of round...
You have to fit the bearing for the intended purpose. A ceramic bearing does not come with an oil seal most of the time. You need to check the...
Just go to any bearing supply house. No problem. Pay a fraction of dealership prices. BTW All bearings are sold in grades 1-10 You can get...
Thanks for checking!! Today was a great day - I found out while removing the valve covers that I have the gear driven cam engine ,the...
I am building a bike from scratch. I got an vf1000F engine from a salvage yard. Today I was removing the valve covers because I want to polish...
It can happen when removing a spark plug that has not had enough time to cool down. Also of course cross threading by not installing with fingers...
Separate names with a comma.
