MORE PICTURES PLEASE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! I been ridng these bikes for for 21 plus years, I got two, my first one...
Kowa is the official Honda Tool. I remember ordering some moon wrenches also known as manifold wrenches and when I received them, was bummed out...
I got zero peg feelers left on my 91 but that was when i was living in North Jersey. Now I am older and wiser. I did walk by my Ysr50 and cut my...
no-0ne MenTioNed the Stylish "duct" tape...Aufwiedersehen :loco: holy chit, I will never speak it
If you have the new style motion-pro tool with the man made blue mercury, as opposed to the old unit that was yellow and used real mercury. You...
MotionPro synch tool is a waste of time. You have to synchronize the tool off the base cylinder before each use, its total :bs: get a Morgan Carb...
:thumbsup: I had total faith...:mech:
Stator, RR with two wires directly to battery, check your startor relay, dollars to donuts the connector and the relay are toasted. Drill works...
^now its all down hill at work, your gona be known as the "motorcycle" person. Need to brake them in. Congrads on that 100,000 mark!!! I have...
Wonder if you bike stored a code or not. 135 is just getting going, just don't do it on crowded roads :crazy:
Roadster Cycle is an excellent solution btw,
Still like the line about (speeled correctly) closing one eye and just "dealilng with it" you could always wear a sham-dana and be a total pirate....
It would be cool if that brain dead post labodimal arse hole saw this post, said truth is probably he does not have a spoke nipple of self...
Your r/r is on its way out guaranteed, you need to check the connector that goes to it from the wiring loom, it contains the three yellows from...
My mother loves the black one, she refers to "it" as her bike :loco: You know I meant calipers not rotors on the above post. Started a new job and...
why dont you have a new carrier machined, thats what I did when I relocated after market rotors or rotors from another bike on a bike in question....
you should solder all the connectors with crimps,solder, shrink tube. I had an issue when the bike got hot years ago, turned out my starter motor...
it would fail in garage economics 101. Would be easier to buy an abs model in the long run, have removed abs from bmws of yore with ok results.
take a picture, I did the rear rotor and had to dis-assemble the rear hub to do this, my high mileage unit I changed the rear pads on and they...
You can start by getting the bike level and removing the clutch master cylinder and sucking out the fluid and inspecting that return hole under...
Separate names with a comma.
