Yes. The starter will usually give you warning signs, as opposed to relays that just stop working or work intermittently . I have had automotive...
This thread is a repeat...
'07 is 42 rear, 36 front. Seems high, but it works well. My first impression (once the tires were properly inflated; long story...) was that it...
Not the button. This is telling you that there is power all the way through the circuit, up to the point of where the circuit should find a...
Guess I'm having one of those days... It just seems like more of the, "Majority need to change so the minority won't suffer" that seems to be so...
My first reaction was annoyance, as I find some subject matter and attitudes much more annoying than the language one chooses to express...
Welcome to the site! We will usually be on our best behavior for a couple of posts, at least!
If it is the original starter motor, it might need new brushes and a good cleaning. Small block Chevy starters used to suffer from "heat...
It is most likely the clutch basket "grooves" where the tabs on the friction disks fit. The friction disks and the basket grooves get worn over...
I remember seeing something on TV about a city in the midwest USA that has three time zones in it. This is ONE city, and it seems to me it wasn't...
Well, the best way to test the relay in place is to remove the green wire from number 4, and connect a wire directly from the chassis to it. What...
So now the hard part; do I sell the '07 now, before everybody sells their VFR to get a new one? Or do I wait to see if Honda really does this?...
Ditto, on all of the above.
If you put a voltmeter on the starter side of the relay (M), with everything connected as it is, it should read 12V (battery voltage) when you...
And I'll bet KC has just been waiting for something like that to happen. :biggrin: :eek:
Congrats on the new bike. If you use the "search" feature in the Modifications forum, you'll get a bunch of info.
It could be a build up of old congealed chain lube, dirt, grit, etc. I've had a few bikes that would start weeping similar to that after chain...
I have used the clip style on every chain I have replaced, and not had any problems. I bought an inexpensive chain press many moons ago when I...
Try yellow on 3, green on 4, and the other two wires can go to 1 or 2 (I do not think it matters which one goes where for 1 and 2). If the starter...
Excellent. I'll read back through the entire post and see if I can figure out which wire colors go where. So 1 and 2 are your power leads, and 3...
Separate names with a comma.
