Ruh roh..... good to see you here!! I am detecting more trouble this weekend......
You could also go 525 chain for a little less weight than the 530.
[ATTACH]
Well, that took me back a few years when I was the son relegated to driving the tractor, slogging small squares and sweating my butt off...
I bought a second hand SpeedoDRD from a member.... works great...... http://shop.12oclocklabs.com/SpeedoDRD/
Re: the bench sync...... I do not know if this applies to these carbs..... but I've used this method on FI TB's.... when the throttle plates are...
I'll confirm..... lowered a bike 20mm at the rear wheel and the side stand angle changed.... currently 7 degrees and IMHO definitely not stable...
Go naked.
You will need resistors somewhere, or a replacement flasher unit that works with LED's. There are LED bulbs with resistors built in.... suggest...
I say keep it OEM..... I think the reflectors look OK, front rectangular is normal on some bikes, although those look a tad longer than the...
An air chisel takes those off in seconds!
Ha, I've been measuring four bikes here, as I need to shorten the sidestand on one of them.... it leans at ~8 degrees with my digital meter, the...
I like the OEM lights better.... can't judge those rectangular reflectors without a side shot.... seems a bit odd they're rectangular. Perhaps...
Straycat's truck musta been out wandering again, look what it brought home. Nice!
Welcome! I went with the more compact species........ [ATTACH]
9000 miles is pretty young by Gen5 standards, awesome even. My old girl has over 65k miles on it. While there is no subtitute for aftermarket...
I have used a few sets of these in various bikes including my Gen5. No complaints. Make sure you order H4/9003. Easiest is when nose is off and...
Is the engine in too high a gear and under load, i.e., pinging? Try dropping a gear or for fun try a higher octane fuel and see if it goes...
Separate names with a comma.
