I also wouldn't switch over to a full synthetic at this point. I think you would be asking for problems. Just do regular oil changes with GN4...
Match the gray. Red would be bold, and probably look pretty cool too... But gray would be classy. Good job! Mike.
I just went a pulled a couple examples out of the drawer... The metal collar that slides into the trac piston is round. The plastic bushing in...
Looking good so far! Here's a couple crappy pics of what the GSM guards look like when installed. Maybe find another lower spoiler to cut up? I...
Very good. Can't wait to see some 'after' pics! I usually don't clear my white wheels. The metallics and blacks I do, but I usually shy away...
And now for something actually on topic: I always spray my own wheels. I use PJ-1 spray paint. It comes in a variety of factory colors (very...
... and the silver frame. Go back and take a look at the dark red VFR model from the same year. Now imagine the bodywork swapped. That dark red...
There are no major issues with running 84-85 carbs on an 86 engine... I ran this set up on my race bike with no issues: 86 tank, gravity feed...
I just couldn't resist sharing this. Came across it looking for some photos of the Hondaline Seat Cowl. Looks like an XR400 (maybe XR250?)...
I think everyone is getting 'squirrely' about 'em and selling them off. c'mon... had to. wait for it... anytime now... p.s. Thanks for the...
Man, the outside picture shows it... clean. Very nice. Enjoy. And... there's a lot of knowledge here in the forum - it's why people are...
Sounds like one set may be California and one set 49 state. But... as stated above... photos needed.
I'd say buy it. Great all-around bike. Best paint scheme of all the F2 / F3's IMHO. Later on keep your eye open for some F3 (or '94 F2) forks...
Looks great! Nice work.
It works... it is approx. 7.5 wt. oil. I'd put 10 in it. Maybe mix half 10 and half 15 for some 12.5. It's personal preference. The heavier...
Try removing the bottom bolt before you remove the springs. Try it by hand first with the forks still in the clamps, unless you have a nice big...
The seat cowls were never officially made for the 86 (in the U.S. at least). It was 84 -85 only. The 86 grab handle is quite a bit taller and...
There used to be an error on the Honda microfische for the Vf500F. They had the front and rear winker stay part #'s swapped. Ordering the front...
Separate names with a comma.
