Did you have the wiring recall done?
I keep spare gaskets on hand but have not needed to use them in years as they do come off intact most of the time. Lean the bike over saves the...
I had a Chrysler product with the same problem back in 08 and after going over it with a fine tooth comb I went back to the basics. After a...
Like Squirrel said, get it off and in your hand. One beer job at the max. It has been my experience that gen 2 starter clutch's do not crack so...
For some reason the needle and seat are not closing on one or more carb. You need to pluck them back off and inspect the float, needle, and seat...
Let me know when your ready to pull the trigger on the shirts.
I like the path with the coast line, and i will be ordering several shirts.
Not that I know of but I bet with a little modification something can be made to work that looks good.
No, it is something that happens at gay golf courses.
It is smoked and have no idea what Tex has on his bike.
I must have seriously bumped my head, they are very different. Sorry.
Lol, I have a brand new aftermarket windscreen. Should have sent it off with you when you picked up the cowl.
I am currenlty saving two gen 1's but they must be worth the save. As described this was a bike tooo far.
Hate to say it but go back to the basics and do a compression check. If it is good then go quick and dirty and with some ether or fuel to see if...
Stick with the 180. There is not one reason to mount anything else.
(The part of Squirrel Man will be played by TOE CUTTER in this post) Most project bikes are going to nickle and dime you to death. This one as...
I would suggest in the future to ask for the spec of each valve. The first service is a base line and all others past that will show a trend of...
I will try to remember to throw a tape measure on my bikes when I get home. The gen 2 has a 2001 swing arm on it.
I am not sure but would say they are the same, will bet a twelve pack of Coors on it.
Run. Run hard, run fast and do not look back.
Separate names with a comma.
