TC, that bike has the traditional, old spring-pull mechanical switch, no ???
Sticking rear brake light is the switch, not the m.c. Removing switch and lubing it more in an upside down position might fix it. First...
That sums it up pretty well, but what's this, you're sounding a bit like Badbilly.
That's great. All you have to worry about now is the valves. :behindsofa:
That should be a good way to verify which is the # 1 wire, but as everyone knows, the Honda cylinder numbering system is a bit confusing.
....but, Crusty, he was using starting fluid to eliminate carbs as a possible problem and still no POPs.....so i suggest he might have wrong spark...
Come on Tinkerbelle ! A squirrel wouldn't fit into a muffler, too large for it, besides they don't like bad-smelling stinky, greasy stuff. But...
On a VFR, don't leave home on a long trip without a multimeter, wire, electrical tape, and a spare voltage regulator. And, at a minimum, the...
People should do research before purchase, NOT after. Could save you loads of expense and frustration. It's old, tired, and making bad noises....
Brit moto journalist Kevin Ash has this to say about Honda's VF series bikes: "........ the dreadful reputation for unreliability of Honda’s...
Glutton for punishment on both counts.
Can of worms. First you pay to raise the rear, then pay to lower it. Geometry is key, and needs to be graphed out before mods and after....
You don't need helmets either in AZ, but how smart is it to ride without one ?? It's NOT ! You're on a bike, not a car, and you need...
Your suspicion is probably right that stronger springs will increase wear on cam lobes and the alloy camshaft holder bearings. Also, increasing...
Just saw it on local CL. I also listed it in our classifieds.... 1984 84 Honda VF750F Interceptor 4 Parts Engine Motor
[IMG]
Blowed up ???? How many miles?? I love my Radian, owned it for 20 years, and it's been one of the most reliable machines ever !! Still have...
Also helps to hold the piston fully retracted by means of a C-clamp while bleeding.....less space for air to hide. You need to be EXTRA careful...
Could they have supplied you with the wrong part ??
The method that works best for me is to first align all the throttle plates so that the first progression hole appears exactly 1/2 exposed on the...
Separate names with a comma.
