How tight should the insulator clamps be on 6th gen?

Discussion in 'Mechanics Garage' started by signal, Sep 26, 2013.

  1. signal

    signal Definitely Not New Member

    Country:
    United States
    Joined:
    Jun 29, 2013
    Messages:
    292
    Likes Received:
    15
    Trophy Points:
    18
    The service manual says and shows that on the throttle body side, the clamps should be gapped at 7mm (+/- 1mm).

    But what about the engine side? I am going to replace my insulators and clamps and want to make sure I got it set right, but I don't see direction on how tight to make the engine side of the insulator clamps, any idea?
     
    signal, Sep 26, 2013


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. signal

    signal Definitely Not New Member

    Country:
    United States
    Joined:
    Jun 29, 2013
    Messages:
    292
    Likes Received:
    15
    Trophy Points:
    18
    I just wanted to follow up to my own thread. I found the answer in the shop manual page 1/17:

    Cylinder Head Side should be 10 +/- 1 mm
    Throttle Body Side should be 7 +/1 1 mm
     
    signal, Oct 2, 2013


    This site may contain affiliate links for which VFRworld may be compensated
    #2

Share This Page