I need the vacuum hose routing for the VF1000F or VF1000R It is not in the shop manual. The shop manual just says to look on the sticker on the...
I have not started it with the stock carbs because I am waiting for some fuel line I ordered. Very anxious to start it. The entire wiring harness...
Maybe it was a blessing you know, the whole deal - because you found the split fuel line and that could have cost you your bike, or you could...
Which bike? What year ? How many miles? A lot of facts left out. I would not worry about these minor things unless there is something actually...
I am going to try a WEBER 32/36 DGV two barrel. I put the stock carbs on but what a nightmare!! Worst of any bike I have worked on. I just do not...
"did you try freash fuel?" Did you try FRESH fuel?
Right on SQUIRRELMAN!!!! WATER FROM CONDENSATION IN THE TANK GOES TO THE BOTTOM. TRY THIS.... TAKE A PIECE OF CLEAR packaging tape and put it...
Why is it that anytime someone is working on a car or motorcycle Someone ALWAYS says...... "must not be getting any fuel." It is NOT the pump It...
Sometimes there is a amall simi circular cut out or the slide does not close all the way at idle to allow just enough air to idle. You have to...
It could idle but then when you try to accelerate the engine it my backfire or spit back through the carbs if it is lean from clogged idle jets....
Today the sun was out and so I decided to put some gas in the float bowls and try to start Quadzilla. For those that do not know I am using a...
NO...It's NOt the fuel pump. Forget that. The idle jets get clogged but not with debris. They get clogged with fuel that has a lot of water in it...
Just try a square drive bit and see if you can get it to move, Tap it with a punch and small hammer first a couple times - NOT a plastic handle...
Removing the top of the reservoir does not bleed the brakes at all. There is a particular order for bleeding different wheels on cars, but not on...
My experience has been that most service manuals say brakes should be "checked", Or pads inspected and or replaced at certain levels. I have never...
Sometimes grabbing brakes can be caused by the diameter of the brake line. The size of the brake line can also determine the feel and feedback to...
Yes ....Follow your service manual. Absolutely AND write down the date that you performed the maintenience and what was done. Some vehicles do use...
I did not say that. I said that when you replace brake pads you do not have to bleed brakes. I have never seen a service manual that has a...
You do not need to bleed the brakes after a pad replacement. You may need to remove the res. cover to let some fluid out if you have trouble...
The video is AWFUL!!! all kinds of NOISE I could hardly wait to shut it off.
Separate names with a comma.
