It does sound like a charging issue, but you will need more information to determine the root cause. You will need a voltmeter to troubleshoot...
How did you decide that a 30 amp fuse was what you needed? What gauge wire are you using for the direct battery feed? If the wiring is actually...
All the fuel jets are clogged! Your carbs are totally clogged and useless without a proper cleaning. If you continue to refuse to accept this...
Clogged fuel jets Clogged pilot jets and "choke" (start enrichment) jets. Alkyhol fuel forms a thick concrete-like sludge in the bowl that plugs...
Yes you can do this on 3rd and 4th gen carburetors, but not 1st and 2nd. 3rd gen have a thick plate holding all the carbs together at the bowl...
It sounds like the pilot jets and/or the mixture ports are clogged. Has it set up for more than 3 weeks with alkyhol fuel?
Ac/dc? Probably not if you were using the DC scale to measure this. If it were fried and one of the legs open circuit, then you would not...
How can it run so low? It has a huge effect. If the voltage is low the FI computer gets false readings from the sensors, hence the surging....
Mount the fork leg back in the triple tree and use the bike as a vise to hold the tube while you put the slide hammer action on the slider. Or...
Hey it was a simultaneous post and you beat me by few minutes--i didn't see your post before i sent mine, so don't take it personal...you did a...
Someone will come along with a picture of the 4-pin connector for you, but the red and red/white wires connect to the fuse post point on the...
Shift Drum Shaft was Frozen... But not behind the clutch on the clutch side--it was on the sprocket side under the small cover for the neutral...
Used an impact hammer to get the nut off and removed the clutch basket. The shifter drum is locked up and will not rotate even with the...
not only the regulator, but how old is the battery, and to what voltage will it reach after being on a 1 Amp charger for 10 hours? Maybe your...
Trying to remove the big castle nut (right-hand threads) and need something to lock the shaft. The manual says to put it into 5th gear and press...
Yes it doesn't really do anything except keep fluid from shooting out the bowl when you pull the lever with the lid open...
Has it been dropped? Are the wheels aligned? What is the condition of the tires--are they rounded over from riding corners or worn in the middle...
i talked to a vf1000r buddy of mine today and he thinks that counter-clockwise could cause engine damage due to the slack/ backlash of the cam...
It would seem that something was done during the valve adjustment that is causing a noise to appear that was not present before the adjustment....
It could be electrical or it could be fuel related. To rule out the electrical side you could squirt a little gas down into the air intake to...
Separate names with a comma.
