Cheesy fan motors made cheap as possible--they don't use bearings but just plain bushings. Steel shaft gets a little moisture and rusts and locks...
Two out of three ain't bad... Let me sleep on it, i'll give you an answer in the morning...
On the street you will probably never want to be wearing the front tire to the edge as on the rear--there is no margin left and no future in it....
No that is the only way to adjust idle mixture. Can you keep it running by using the choke? The choke lever opens up a circuit to pull fuel into...
Yes that is the #3 pilot screw you circled and yes you need to adjust them to get the proper mixture at idle and the idle speed. Were these carbs...
There is just one line and the fluid has to flow both directions. The return port lets the pressure bleed back to the master out of the slave...
Is your chain too tight--it must be loose enough to still have sufficient slack not to bind the suspension when fully loaded in a corner at the...
The only problem with the welding tip cleaner rods is they have burrs on the shank intended to cut and remove slag--they will also easily cut into...
Unfortunately there is no adjustment, but there should be a slight free-play in the lever. It does sound as though the tiny return orifice may be...
This sort of surging at idle makes me think it is related to the throttle position sensor TPS. If it also happens at partially open throttle at...
Sounds like a carburetor issue--not getting enough fuel. You will have to ensure the fuel system is clean and functioning from the tank to the...
fuel: clogged carburetor, pilot and choke circuits, not getting any fuel. electrical: measure battery voltage while idling and at 3 to 5 krpm...
Simple squidbilly closed loop mixture control: the O2 sensor generates a voltage proportional to the differential partial pressure of oxygen in...
i don't know squirrelman i don't know why i said that-- i must be gettin' jigglebillie in my old age. But i got these night vision...
Small wonder it's fubar--It can't run closed loop without the O2 sensor. Who's the brainiac that came up with that idea--that resistors could...
aka clogged peturcock or broken vacuum line to petcock...
Good move on getting a meter. It is telling you that the battery is no good. You can also use the meter on the beeper continuity or ohms setting...
What size pilot and main were in there, and what size did you put in--one step up doesn't tell us anything. Did it require choke to start when...
Does your bike still have the weights that are bolted to the back of the footpeg brackets? i can't remember if it's on the passenger or pilot's...
It is a somewhat unclear document, but appears to say do it to all 8 holders, one at a time. Not a difficult or hard task, just time...
Separate names with a comma.
