Given the title of the post is "Emergency regulator swap" I think it is clear that DeeBee is not advocating using a single phase R/R permanently,...
My Chinese peg is doing just fine after nearly a year of use. May be easier to screw a thin plate to the peg mount to push the bottom of the...
The switch to chain driven cams is probably cost saving although I suspect noise limitations were part of it as well. The gear drives are pretty...
They HAD to get this one right; their previously snow white engineering reputation had taking a pasting with the previous generation VF750F which...
You'll note he is only flying over water; one little bobble (and who hasn't done that on a skateboard?) and you're headed for the ground/water....
Take a look at the following link to the ST1100 owners forum, where there is an awesome pictorial of cleaning out a V4 carbs. While I appreciate...
I have used Motor-stickers.com for decals for my VTR1000 and VFR800, and the quality and reproduction has been first rate. I see they do a set of...
Hi Newbie Welcome to the forum, lots of helpful souls here, so ask away. Let me start by saying that the picture above is a VFR1200, a very...
Might be time to start tracing the power feed from the battery/fuses to the bar switch then the flasher relay. If you hook a multimeter or test...
The flats are there for assembly of the adjuster only. [IMG]
The modified CBR929 shock has the same adjustments as the original CBR shock, namely a rebound adjuster at the bottom, and a single low speed...
The three relays are for the hi beam, low beam and blinkers. The blinker relay is the centre one. Do you hear it ticking on/off when you move the...
The way the FactoryPro ignition advancers work is by replacing the stock pulse generator rotor that triggers the ignition timing. Simply changing...
Your front turn signals should be on as running lights all the time except when you use the indicator switch, then running lights drop out and the...
The clutch fibre and steel discs are coated in oil, and when the clutch is cold the plates will stick together. If you put the bike in gear, pull...
Thanks for sharing that Lucky Strike. That would be a plausible reason for the OP's overheating for sure, and would explain why replacing the...
Here's a link to a pdf service manual for your bike. Do you have LED bulbs in the turn signals? If so maybe you have the power and earth...
Try Partzilla: US$68. http://www.partzilla.com/parts/detail/honda/HP-37760-KS4-880.html
That reminds me; I must check the tyre pressures and change the oil. Thanks Lint. Sent from my iPhone using Tapatalk
FactoryPro make ignition advancer rotors for a good number of bikes, and usually offer 2 or 4 degrees. I had a 4 degree advancer on my RF900 but...
Separate names with a comma.
