Looks like the connector has corroded which caused the build up of heat and then melted. I would replace the connector . Or just chop the...
The 6th gens have an idle adjusting knob , the 5th have a hole in the frame for a screwdriver to be inserted.
It's top money , but at 6000 miles it's probably worth it if it goes as good as it looks.
I've had trouble lately with my engine temp sensor connection being corroded. The display did read - - and it went through a tank of fuel in no...
What Greg said , heat is your friend here. I could not for the life of me undo the big 43mm nut from the rear hub. Got the heat gun on it and she...
Contact a local bike breakers to see if they've got a reg/rec from a yamaha r1. Thats what ive got on.
Ok so its not fuel. Must be electrical so beyond me sorry. Im sure somebody more capable will be along shortly. Good luck as it looks a tidy bike
Blocked injectors ? Does it idle correctly ? Must be fuel related It looks good for $1k . For that kind of money here in the UK you'd get a box...
Ive always had a very sporadic gauge reading , one minute half a tank next bend flashing empty. While going through as many connectors as i could...
Balance the starter valves would be my first job. Its fairly easy and is essential for idle and low rpm running.
I had a right nightmare bleeding my clutch m/c. The first time I did it was easy and straightforward but the last time it would not operate the...
Front tyre not balanced would be my first guess. The rear tyre can not be out of alignment with a single sided swinger unlike a conventional swing...
I've just got back from a 30 mile ride and noticed my volt meter at a stop light , now I'm worried. I set off from home to the first set of...
Thank you for your advise Rllw Joe, that is what I was thinking but all is well now. I traced the wire from the sensor to where it plugs into the...
Thanks for the reply. . This is the bit I can see but it still looks connected. I need a tiny pair of hands to reach in and wiggle it just to make...
Hey everyone need your help. . I replaced my clutch hose due to leaking fluid and now the engine temp just reads " - - ". The air temp works ok...
Good advise get a vfr400r-nc30 or rvf400-nc35. I had a nc30 and its the only bike I regret selling, brilliant little thing. The nc35 is the...
Your top upper and lower yolk clamps are probably out of alignment. Slacked off the handle bar , lower yolk , mudguard and fork bottom pinch...
Glad you got your old fuel sorted. I'd probably run some Redex through , had good results with this in an old vw that ran out of fuel and dragged...
I'd say YES get a vfr you'll end up loving it I promise. I'd only had 125/250 s for years then bought a 5 th gen because it was mega cheap but...
Separate names with a comma.
