Are you aware that creem has proven far inferior to the epoxy-based www.caswell.com fuel tank sealer and is likely to flake off, causing fuel...
NO, most likely the calipers need a cleanup and new seals :(:( mas o menos. :Yo: Or maybe a spacer is missing on the axle/wheel ? :eek: Over...
At that mileage it's overdue for new wheel bearings (likely), headset bearings, fork oil change, bushings (maybe) ........ unless you see receipts...
I 've worked in too many shops where the owner lied consistently every day promising jobs that wouldn't be ready when he said........ When the...
Drive over to the shop and ask to see your parts and work in progress. :Faint:or :Bravo:
Consider installing a fuel on/off valve and filter beyond the petcock.
try this.......https://www.hawkgtforum.com/forum/honda-hawk-gt-bros-discussions/mechanical-and-technical/830518-attempted-petcock-rebuild
Good work ! avoid getting cleaner spray near the rubber slide diaphragms. lacking ultrasonic, carbs must be cleaned by hand, using green...
Probably too far for Randy, but i may be there on July 13, having attended 4 or 5 previous events. "Canada's Daytona bike week !!" INSANE !
I also have an ultrasonic cleaner, do alot of work from this forum, and my usual carb cleaning rate is between $195- $225 (+any replacement parts...
Yes, unplug pump. After the engine dies, turn the choke to full, and run that circuit dry too, about 10 seconds. there is a small problem with...
FSM states 7mm for '86 700, and 9mm after '86, possibly for stricter EPA rules ? with new needles and seats, i can't imagine what might cause...
dupont the corporate criminals ? https://www.democracynow.org/2018/1/23/dupont_vs_the_world_chemical_giant
guessing might not be sufficient, so do some measuring. :Yo: what # did you try to hit when setting levels ? holding needles up by hand might...
[MEDIA]
anytime you acquire a new old bike it's best to drain and FLUSH the fuel tank, first thing so crap doesn't get into carbs. seems like you need to...
Hey, you didn't get the message ? when removing or replacing the carbs, the airbox bottom should always be attached to the carb set !! yes, as...
I usually call "Cheeky" my blacktail prairie dog (Cynomys ludovicianus) a "wee beastie" in Burns' honor, of course. [ATTACH]
My thoughts exactly ! :Hippie:
the exact same (or easily converted) fuel pump was used on many pre-FI bikes from several manufacturers on many models over many years, so finding...
Separate names with a comma.
