how close ? within the width of the needle. control idle speed to about 1200 -1400 when adjusting synch screws.
you need to get them alot closer than that. remember that the sequence of synch screw adjustments is important and to blip the throttle a couple...
a properly applied chisel with the right point and ramp and right-sized hammer will lift the bearing race easily and instantly but you'll need a...
old school used baking soda in water, run it up to temp, then flush.
it's in the manual, read it.
look for FI codes
nice tool to have but entirely unnecessary :rolleyes: just be sure to recheck clearance again after you tighten the locknut as it may have...
check tire pressures. if too low they can make you feel like you can't control the bike properly.
not likely 4 coils just went bad, gotta be something else. test meter must be set to the correct range to get good results. never mind the meter...
be careful not to overtighten the long bolts holding on the slave cylinder.
5800 miles and you replaced wheel bearings, chain and more ? o_O OCD maybe ?
could be over-rich mixture screw settings so try 1/2 turn in. how does it idle, and will it start easily without choke ?
copy printed by 3D, fits well. [ATTACH] [ATTACH] $33+shipping
probably would have been smarter to spend a year learning and riding a smaller bike, eh ? RAEVA MI VERKER !
sorry i don't have a slick website, but......... i'm fully equipped and experienced to do any VF or VFR carb rebuilds at any time for members...
WELCOME ! do you like squirrels ? [ATTACH] you'll need to post photos of your bike/
be sure you get the sidestand cover :p
your assumption may be incorrect, and tuning is never based upon assumptions ! have you checked the plugs' colors ? capt80s suggested you cover...
when i first got my '97 (around 2000) it surged alot at small throttle openings and was too lean, so a turn and a half open on the mixture screws...
as stated, you only need to remove 2 carbs, either left or right, but it helps alot to loosen (but not remove) screws on the remaining carbs so...
Separate names with a comma.
