i test O-rings by holding carbs upsidedown and blowing air into the fuel line. spray soapy water around the tube ends and look for bubbles. >>>...
BAN THIS IDIOT
do you tend to over over-worry about things ?
it's a personal preference of course. you would need to sit on another vfr to know. my guess is that police changed bars to aid quick U-turns in...
your rotor is probably fine as the surface marks look good. measure the rotor to determine actual thickness compaAred with minimum listed in...
3 things a new 'cycle owner needs but may not think about: 1-amp battery charger multimeter volts/ohms small air compressor for tires
suggest you convert to standard vfr handlebars. mabuhi :cool:
difficult bike to ride for beginner without some practice and experience, so get some training. service manual is available online here. be sure...
THIS daft a-hole thinks it's OK to advertise cripto spam on our website......what ? :Ban:
the washers need to be fitted with the copper-colored side UP........if i remember correctly.
yes, you can do that but any VFR mods need approval by 34468 Randy. buy the man a drink.
^^ a stator in failure mode provides less voltage, never more.
you rebuilt the waterpump ?? oh goodness, that's not ez. cool trick, lad :Nod:
whoa there, cowboy, you need to do something before you go further...... the bent butterfly will have your bike running erratically and never...
it's not right to change float settings to cure a leak :confused: consider replacing all the float needles. your throttle shafts look...
test the AC output from the stator, and do the simple resistance tests--all in the manual-- before jumping to conclusions. testing the r/r is best...
don't trust any $ 25 chinese pump; do what 50th vfr suggests above first b4 replacing pump. pump relays fail more often than pumps. unless it's...
during storage a fuel pump might have a stuck or sticky moving core, which will fry the ignition fuse from excessive current draw. i've seen...
for that broken off brass tube (air corrector), i'd suggest finding or making a tube to fit, with similar hole diameter and jbwelding it in...
ok, thats good stuff.
Separate names with a comma.
