[ATTACH] I did do the air test all slides worked just fine. I hooked up a fuel rig and line earlier today, see picture, it fired a couple times....
Sure do! Whatcha Need?
In contemplating not being able to get my petcock valve cleaned of goo has anyone used an inline filter between the fuel valve and the Y junction...
Time to rig a fuel bottle to test and maybe balance. Decided to ultra sound the Petcock again. Still very grubby. More Later Wavey[ATTACH]
[ATTACH]
Got the carbs, gas trans tubes, air tubes back together, and bench sync'd . Leak checked no leaks. I hope to rig up a bottle with some gas and...
Hey Capt. Did you do the DMR VF Petcock Mod . Mine is totally gumbed up and by the sound of my research, I think modifying to non vac on - off...
What is your guess?
Gas went through so fast it was hard to determine where it came from. I am suspect of fuel tube junctions and fuel supply hose from Y leading...
Leaked checking carbs...Gas poured straight through them! Are the gas crossover tubes the biggest culprit they? Should somthing else be plugged...
SM shows fuel strainer inside of strainer cap(Red Circle). I did not find such a thing upon removing the cap? Don't see such a thing on E bay...
Good one.. I aim to do just that. Thanks On a side note ...why does a petcock need vacuum? And what is it supposed to look like at the base of...
[ATTACH] Hello, I had to take a step back for some personal stuff, relocation and other. I managed to get some time in and was able to get the...
Guess I will let that one go. I am not feeling I want to go that deep into restoraton. I want get the bike to run again.
I am looking to replace Left side tank Winged Honda Decal this link is to a not available example at CMS in theNeterlands...
Thanks for the tip again! Yes removed and cleaned. By the way I don't recommend putting Gumout in an ultrasonic degreaser!!!! Unless you like...
I was confused, probably from the smell of various volatile solvents in my garage? I am talking about Synchro screws. I did not touch the...
Is there any home brew Pilot Screw Adjusting ideas that don't cost a rediculous amount of money. I can smell the finish line, no not really.
Going to look at Autozone today for some preformed stuff off the rack? I ordered some 1 mm x 12mm long cotter pins to replace the linkage pins...
Separate names with a comma.
