4th gen VFR here. Ok, so I've removed the windscreen and headlights, and want to disassemble the remainder of the front fairing, which is composed...
Looked down into the intake ports today, and the valves have all manner of black, gooey looking shite on the backsides of them. I've done the Sea...
I ruptured a section of fuel line today pulling it off the petcock. Figured it had seen better days and I'd just replace it along with the other 2...
Looking to replace my stock muffler w/ something that has a bit of a growl - nothing too insane. I see brand new Delkevic stainless on Ebay for...
I see a 3rd gen Yoshimura muffler posted in the classified section of VFRworld. Anyone know if that will fit a 4th gen? I looked up 3rd vs. 4th...
Got Jamie Daugherty building a CBR929 rear shock for me, as well as rebuilding the forks. Has anyone needed to replace worn needle bearings in the...
While I had the carbs apart for cleaning, I cut a notch into the pilot screws so I could just use a screwdriver to make adjustments. I have the...
Not sure of the order . . .
Can someone tell me what "tang" I'm supposed to be bending to adjust my float height? The float is all plastic, so I'm thinking the 4 little...
Probably be much quicker than ordering online. Definitely cheaper :playful: I'll post what sizes I have and what I need when I get home in a few...
In my Honda Service Manual I see references to the "Common Service Manual". Any idea what it is and where I can access one online?
I just swapped in a bunch of new shims. I now have a few intake valves with .008" clearance, as well as a few exhaust valves with .012" clearance....
Cycle Gear has the Bilt brand Trackstar boot on Sale. Regularly $159 for $59. Not the highest quality boot out there, but for the money it's a...
New to me 4th Gen with 17K miles - hasn't been run in a couple years so I'm going through it. I have only 2 valves within spec!! The intake...
Doesn't seem to want to come out. First I tried pulling it out with one of those right-angled pics, then prying it out with a screwdriver. I know...
The manual say's they're set from the factory & don't need adjusting. I also don't see any reference to them on most of the carb cleaning...
I don't want to bugger 'em up getting them out . . .
Gonna be checking valve clearances on my '95 w/ 17K miles. Are the cylinder head cover gaskets usually shot and need replacement? If so, I'll just...
Just bought my first VFR -been waiting a long time. In the past I've owned CB-350s, RD-400s, a BMW R-65LS, and a Suzuki GS-850g. This is a '95...
Separate names with a comma.