Atleast its not a car where the taste of oil and atf is different. but then again the smell too. Check to hard line flanges on the oil cooler,...
Check your batt voltage before starting, at idle and at 5k rpms. Start there, and post your readings.
new subframe. Extend the lower strut, but might as well build a new subframe. Also note if you do either mod, you will raise the angle of the...
To anyone that knows, The 01 R/R has 5 wires, 2 Green, 2 Red/White, and a small black/white wire. What is the white/ black wire going to?
My 01 is a salvage. Im rebuilding it however and almost un-recognizable as a VFR. It was a insurance write off because of theft and it was low...
And so it was a happy ending. There is spark, there is fuel there is fire. I replaced the IPG, and converted the 01 VFR to a 99 EFI system. No...
thats a fun drive... used to live in between, MD.
keep the rubber side down!!!
tell you the truth, I should just check all the connections for corrosion on the old main harness. But Im semi color blind (so I think) The...
I have a Yuasa sealed batt. Can I place this in any direction? IE lay flat, or does the terminals have to be upright? (Reason I am fabricating...
with the choke/ idle, are your jets clean? when was the last time your carbs cleaned? or an idle screw is backed out too far. How long does it...
Thanks Dizzy, I was really unsure about the CDI, so I sent it to a bussy of mine in the East Coast, and it tested good. So its still good. Im...
Give me call I work in San Diego, but a Franchisor for Shipping/ Freight Companies. Call me or Pm me details and I can hook you up with one of our...
Also on the checking the grounds, I could not get resistance on the PG or the Clutch switch on the CDI connector side. (even when I pull the...
Thanks Dizzy, Ja, the PG is toast per all the tests. This is on a newly charged batt at 13.8 v. (slight over charge) My question is, shouldn’t...
Check the Stator AC measurements. Could be batt, RR or Stator. A bad batt could not take charge, but rule out the charging system first.
The IGP seems to be bad. Charged the batt over night, checked the voltage, not getting anything over .04v this is after 10 tries. Per the manual...
da black, Im having the same issues aswell. Hopefully my findings can help. So your bike cranks (starter starts) but the pump is not...
Thanks Dizzy, I checked the grounds, from the CDI side with the CDI disconnected. All the Ground wires were reading 0.00, .001, though it...
Ok, Im checking for resistance on the grounds and I cant seem to get a reading. Im testing the multimeter in all the settings, 20k, 2000, 200k...
Separate names with a comma.
