Did you clean the air port passages on thie intake side of carbs sound like they might be clogged? I had a 85 vf700 and mine did same thing I...
You can go to cheapcycleparts.com and look up part #s on there site. Hope this helps.
OK is there a site I can check on adjusting the Idle jets on the 700 seems that the Clymer I have runs me in circles. The bike runs like a raped...
yes throttle was held wide open during test the only things that wern't open was vac slides :cool:
is that the inside slide w/the rubber on top? or is it a part of the choke?? here is a site to try. pacyclesalvage.com and cyclesalvage.com if it...
runs great no smoke no hesitations it even idles better than last year . think i'll do what toe cutter said run it like i stole it. was told that...
dry i didn't put oil in top of cylinders. i have tryed to do leak down in the past but had no luck doing it by myself had to much air pressure...
OK i decided to tear the heads off my 1st gen and have a valve job done and have cylinders mic,d the cylinders and pistons are within specs have...
I'm looking for the valve spring compressor tool. have a home made one but is a pain to use. I took valves off of rear head and tried to use valve...
does any body know ware to find the Honda valve spring tool shown on page 97 in the Clymer repair manual? or is there something else i can use?...
try pacyclesalvage.com they seem reasonable.
still a work in progress[ATTACH].
Thank You when it comes time I am going to call the places above and see if they can help me before i order the 87 vfr700f2 p&r. It will be...
Can any body Tell me if another over sized piston will work in my 85 vf700f I need to bore it out and cannot find over sized piston and rings...
Had same problem try switching the plugs around even though the plugs are new doesn't mean it is good.:cheersaf:
Thanks for the input the only reason I ask is that I put standard rings in last year and had someone hone the cylinders for me and they took to...
Has anyone heard of putting over sized rings in a standard bore and if so what the out come was? I know i need rings because compression is low...
I would start by taken bulb out and seeing if the filament is burned out check the fuses they are around key slot and check wiring under the rear...
Is there any way of telling when one is going bad I know ether they work or they don't bike is running fine just doesn't want to idle . the...
which way to richen the mixture????
Separate names with a comma.
