Thanks I live close to Bear Mt and drive through frequently (mid week :) away from the deer Have knew thermostat coming (OEM ) was not going to...
Thanks I'll look into fan today, but my experience is fan rarely went on in normal driving and temp rarely climbed past 1/4 gauge. Maybe I just...
97 VFR 54K Oil new and level, coolant changed 2013 but has correct amount. Bike running hotter under normal non-stressful riding at 70-75 deg...
Update More confused now Previously Their was 12V at connection (speed sensor to harness) when back probed. Pink wire has continually at...
Ran test On speed sensor - Hooked black line (power) to 12v battery Posi Hooked Green (ground) to 12v battery...
Thanks for that. I will check tomorrow. I was able to track down FSM My manual didn't have test procedure. I thought that I should get 12V at...
97 VFR Speedometer stop working. Before I order speed sensor was looking to test to make sure. Is their a troubleshooting guy someone could...
Cut right side header. Came right after that
My unit has all been welded together awhile ago. It seems like it wants to come out but locks up on stand. Thanks
Book says you unbolt fastener from left, then pull out bolt from left. Then says to watch for washer at right side of center stand bolt. Did all...
97 Vfr Taking out exhaust to replace and make some repairs Center stand has 1 12mm bolt holding in shaft shaft gets pulled from left...
I now have about 750 miles on the 180 rear At 200 miles I was disappointed and started playing with the air pressure based on some numbers found...
After 200 miles I'm disappointed in the 180 rear (180/55/17 PR3) 42 PSI more effort in turns bike wants to straighten up much sooner Braking in...
Thanks for the help. I really liked the PR3 for wet weather. The PR 4 on the front is a nice improvement over the PR3 so i'm disappointed in no...
Hello 97 VFR Currently have a Michelin PR 3 on rear with 20K and needs to be replaced now. Front was replaced at 17K to a PR4. Like the 4...
Anybody have anything on this? Thanks
Green connector: The burned trace is coming from B/Br. List below is readings from connector at PCB B/Br - 12v R/G - 12v L/B -0v Y/B - 0v B/Br-...
Hello This is a year later :( I just got around to pulling out the dash. I have a broken trace. Location is arrowed in picture. The trace was...
VfRness is installed with new wiring and connector to solenoid. Seems Solenoid is bad, wanted to get advice or test procedure to make sure. Batt...
I previously posted a burnt connection at relay. VFR 750 4th gen Installed new harness and blew the 30 amp on relay. I thought i followed...
Separate names with a comma.
