That’s a possibility. Will have to do some more googling I guess.
Opps....just re read your message and I do have the slides out of the carbs. My problem is getting the old diaphragm off the slide and the new one on.
Thanks for that info. The one that I have pulled out was the bad one and the diaphragm just tore away as I was trying to get it out. Will give the...
Have bought 4 new diaphragms for the old girl, one was split badly. Has anyone changed them before because for the life of me I can’t see any easy...
Thanks for that, will have a look and see what I can find out. In the process of re setting the valve clearances at the moment. Cylinder 1 and 3...
Hi all, Anyone have any tips on the best way to sync the carbs on a 1986 Interceptor? I have rebuilt all four of them, new jets, o rings, set the...
Had a look at those sites and the same as most of them around the world, no longer available. Guess I’m going to have to wing it and try and...
Does anyone know if anybody has or makes the infill panels that go between the front fairing and the tank for an 86 interceptor? Any help would be...
Have adjusted the floats and to around 7, 7.5mm and gravityfed fuel. NO LEAKAGE!! Hopefully problem is solved. Hydrographics is the art of...
According to manual float levels set to 9mm and that’s where they are. Needles and valve seats are all brand new along with jets and pilot screws....
Thanks mate, sliders are working fine. Tested the needle valves by holding them shut and gravity feeding fuel. No overflow. Put the bowl bases...
:dislike:No, I didn’t. Looks like it’s time to pull them off the bike again.
I have just put this bike back together and fired it up and have quite a lot of fuel coming out of what appears to be a breather. A bit hard to...
Hahaha......yep. Thanks for your help mate.
Yep, that looks like the problem. Can see a small amount of oil in the two rear spark plug holes. Going to be a pain to get to the front cover...
shirmik: Hi all, have just got my 86 interceptor back together and fired up. Motor was taken out of the bike and only the cam covers were removed...
I have an 86 750 (RC24) and I am assuming that the carbs have never had a refresh. Very hard to get bike to rev as it should. At one point, it...
Had a feeling that was going to be the case. I do have other leads here but are too long in length and the boots going over the plug are almost...
Does anyone know where I can get a set of leads for an 86 VFR 750 FG (RC24). Thanks.
Separate names with a comma.