LOL...You're right... Missed it by one letter. VF1000R ;0)
Thanks Squirrelman. Good advice. I gotta tell ya I took the bike for about a mile ride yesterday between rain storms, and it runs great. If...
Right now they are set at 2 turn out. I need to just ride the bike to see how she feels. The filter is stock from EMGO. There is a Yoshimura...
Yep...The fuel pump contacts are on the list of things to check. I took Captain's advice and added a short length of tubing and ordered a Uni...
Okay, believe it or not it worked. I removed the cap from the air tube (yellow arrow) and success!!! Thanks again for hanging in there with me....
Wow! All those parts have been removed from mine... It must be lighter... Jason, Good catch! I'll remove that cap today and hopefully you...
Bad choice of words...I think the official Honda names for these tubes "air joint pipes". Carbs 2&4 are connected with one and carbs 1&3 are...
Good to know Captain. I was just in the garage making sure each smog port was plug on each of the carbs. They were. And that the large tubes...
I read the following in another thread about removing the CA smog hardware. My 1987 VFR700F2 is the CA version with all the CA smog hardware...
Sounds good. I've got the adapters. I now know what screws your talking about. I found this picture in another forum of where the vacuume line...
Don't worry about insulting me, I get it. If I start the bike right now I will need to start it with full choke. I never take it off full choke...
I enjoyed your conversation. I had a Ducati 900SS where the fuel pump primed the carbs at startup. Once it reached the desired pressure, the...
Thanks JasonWW. Good suggestions on the float levels. I'll check it out tomorrow. I didn't spend a lot of time on it but I did make sure all 4...
Just when you think it's safe to go back into the water! OK... When I start the bike with starting fluid (I know I shouldn't do it) It idles...
Thanks Jason...Right now they're at 2.5 turns out. I'll try 2 out tomorrow after she warms up.
JasonWW, I couldn't have done it without your help! Thank you! I was actually able to replace the choke valve with separating the carbs. I...
My Float valves and seats were fine. The little spring loaded extention on top of one was sticky but after cleaning it worked fine. My jet...
I answered your questions above...Thanks again for your help, and Merry Christmas.
OK, I'm getting closer! I've cleaned the carburetors and all the jets, replace some of the pilot screws, replaced the gaskets and all the Philips...
I like the whilte paint idea! Good one. It will make the adjustment much easier to see. The drian line missing, is with the tank. It was...
Separate names with a comma.
