Float Seat washer too small

I got my 2 new float seat, washer, and pins today. Problem is that the washer is only half as thick as the oem. This is going to raise the floats slightly putting a bit more gas into the carb. how much difference will this make? will the 2 carbs be running too rich? Do i need to ajust the carbs. they are still synced. I didnt take the carbs appart, took the whole assembely off.

If I do have to ajust the carbs. How do i go about doing it.

1986 vfr700f

thanks

 

Re-use old washers with new float seats and pins.

problem solved!

 

he's right!

but first lightly sand the old washers on fine (600) sandpaper.

check float heights, of course.

 

the problem is missing washers

 

Huh?

Your bike's carbs didn't have any washers to begin with?

 

yes they did. but yours truly lost them.

update:
http://vfrworld.com/forums/mechanics-garage/19240-hope-restored.html#post135255