Glad to hear it worked. Don't forget to follow break in procedure for brakes :thumbsup:
I would def lube those pins, as that can stop the pads from moving correctly. Also, I could be wrong here, but I think improper bleeding can...
How did you determine the brakes are dragging? When up on the center stand, does the rear rotate freely? If you pushed in the pistons, there...
Good observation, I just bled my brakes and clutch and my shifting is much smoother. Never count on the dealer to set up bikes correctly! I used...
Not quite, the clips didn't even come out when I removed mine. 1. Push in the pistons (by pushing on the calipers) to make room for new pads 2....
[IMG] AGV TiTech here. BSI certified instead of the usual snell, very light weight and great venting helmet.
I just did mine last month, it took about 5 minutes per side. Absolutely no need to take off the wheel. The only hard part was holding...
Nice, lived off 14th for a bit too. Not the best neighborhood, but always exciting :stripper: Good looking out speed, I used the one without...
:thumbsup: Another thing I never see mentioned, splitting lanes at traffic lights greatly decreases the likely hood of being hit from behind....
Sure. Don't forget to bleed that sucker good too. No idea on the hose, sold that bike last year. I think I just took off the old one and walked...
Not sure if it would be the same, but this is from the sab/mag faq (I used to own an 86 vf700 magna and the cap worked fine). Pep Boys, the Stant...
I can do it on a relatively flat road for about a second. Has anyone been hassled by the cops for not using both feet at a stop? I haven't, but...
:thumbsup: I started riding at 15 in Colorado, no helmet law. I can't say I didn't have my squidly moments back then. When you're that young...
Drink a beer. Answer to all lifes questions :)
Holy crap! Can't believe that last post was over a week ago. As much as I love my job... I'm not a big fan of the weeks worth of after hours...
Separate names with a comma.
