Yeah, I realized my error after the fact. The jumpers aren't individual wires, it is groups of wires.
Well, I got no fuel pump prime from soldering the individual pairs for grounds. I cut each pair off the orange connector and then soldered them,...
I did cut off the connector and I soldered each pair together. I see now that was unnecessary to do it that way! :P
Well, since we are here. I found that orange connector under some black electrical tape. Would not have looked there if you hadn't pointed me...
Ah crap. I didn’t notice this was a 6th Gen thread. Also, I have the bike on the center stand. I can still lower the side stand of course....
The bike cranks and fires right up. The FI light flickers and comes on dimly. If I rev the engine to 5k the intensity of the FI decreases...
Bump, reading this because my FI light came on and had to limp the bike home. New battery before the trip. I should have charged it just be sure...
Old thread, but it helped me this morning at 3am when I couldn't get my clutch bled after replacing the slave and rebuilding the master cylinder....
This is good to hear. I just bought the 11 line set for my 98. This topic is timely for me. I am rebuilding the both the clutch and front...
Separate names with a comma.
