I ordered a Brembo rear rotor for my 2006 non ABS VFR800. Checked with multiple sources including Brembo itself and all said it was model...
Will be changing the rear brake disk on a 2006 non ABS VFR and am looking for some recommendations for grease to use on the bearing, spline and...
This is an odd one. A 50cc Aprilia. https://www.mecum.com/lots/1129154/1996-aprilia-rs50/
Beautiful model, no reserve, dreaming is free. https://www.mecum.com/lots/1129126/1993-honda-vfr750r/?aa_id=642989-0
This is what the meter looks like. It is on the left (clutch) side inside panel as shown in an earlier post on this thread. Easily seen when...
I am away on vacation for 2 more weeks. Let me see if my wife can send me something to post. But no doubt step bit is the way to go. The control...
I used a step bit and it came out very clean. Good thing about it is you can drill, stop and check until you have a perfect fit. My meter fit nice...
OK, another question. This is the bonus round. I am going to install a voltage meter, specifically this one, which can be turned off....
Now a question about the RR and stator connectors that are near the RR itself and are in good condition, I would like to remove the terminals to...
Thanks for all the great information. Still deciding between connector based or direct soldering of the two wires. Another option is putting in a...
Looking to replace toasty connectors on battery harness. These come from the 30 amp fuse near the battery. Can anyone tell me the wire size or the...
Separate names with a comma.
