Don't know if this helps or similar to the USA version, but it's the only ABS 6gen diagram I have.
For a cold start Yes. As mentioned and if you look at the wiring diagram the ECT has two independent sensors within the one unit. It's quite...
Have you tried removing the airfilter housing and closely monitored the action of the wax unit acting on the syncronisation plate and linkages...
My 8gen with untouched SV's and untouched Wax Unit. Stable idle speed of 1200rpm happens at approximately 50degC or 122degF.
Hmm good point about your altitude, 6700ft above sea level, assume the Honda vac specs are probably for sea level, I'm at about 800ft above sea...
Terry's explanation is spot On, you should not have the Idle Adjuster Rod touching the Synchronising Plate with a Cold Engine. Your...
I wonder whether these before and after photos of my 2009 6gen synch might help. No messing with #4 so perhaps you could replicate this situation...
Don't waste any time and energy checking other things! As has already been mentioned, FIRST establish that you have a healthy battery AND your...
Absolutely me too!
The attached photo explains how to keep the vent hose unkinked when lowering the tank, it's vitally important to do this, take up the hose slack...
If you replaced the battery with your Ignition Switch to OFF then you can't damage the ECM because power to it is isolated by the Engine Stop...
What is the state of your Battery? Was it charged while in storage? Low battery voltage and poor battery capacity can cause strange issues! - FPR...
When stationary with the Sidestand down Ignition on does the Fi light flash a code? - A very common issue is Main Fuse B 30amp next to your...
- Is it still flashing the code? And only with the Sidestand down? - Do you experience any adverse effects with the bike when the code is active?...
Hi Daniel. I can't believe this could be a complex issue, surely the answer cannot be too hard to find.....maybe! Had three 6gens and not a single...
Separate names with a comma.