Listed on ebay as "Universal Handle Bar Riser For 41mm Fork Honda VFR 750 800 VTR1000 CBR 600 1000F"
Was wondering if anyone here has tried these? Did they fit? I know that the bar ends will contact the windscreen with these on. Just thinking...
Hopefully the missing small vent tube O ring was the cause of the strong fuel smell....although since the small vent tubes are open to...
I replaced the fuel and vent O rings, found one small vent tube O ring was not there. The intake boots were more like plastic than rubber, so they...
I removed one O ring each of the three sizes....none of them cracked. The large vent O rings are the most squashed ones, look more like a square...
Quick update here: carbs are off and I just separated the two halves. All vents and fuel tube came out very easily.....too easily I think.... I...
What other O ring sizes should I get for the carbs since I am putting an order together?
I sure hope this is a small issue that can be addressed.... By float bowl O-ring do you mean the formed one between the carb body and bowl? If...
I only mentioned the fuel petcock not shutting fuel off 100% as a problem in removing the tank with a lot of fuel in it as fuel would dribble all...
Nope, ,you have them correct, the parts description is incorrect; #4 & #8 are the SM vent tubes and #9 are the fuel tubes. And yes...that bent...
What confused me is that for #4 &# 8 the part description has "Joint Set, Fuel" and #9 just has "Joint Set". I am going to take your advice,...
Capt - need a favor; could you take a look at the carburetor assy diagram for a '97 at the partzilla.com site; it seems to me that fuel tubes in...
Today took the VFR out for a bit, got engine to temp, returned to garage and once again began checking for any drips or wetness under the...
Yep, I know of the ebay seller, have purchased previously purchased from him for another Honda I had. The set of two aluminum tube with O rings is...
Separate names with a comma.