I did provide plenty of ventilation in the bags. I am mainly concerned with water splashing up and onto the wheels and underside of the bike. I...
Took my last ride of the season today. Beautiful sunny day here in Boise. On the cold side however but my gen 3 sure likes the cold air induction...
I removed a complete PAIR system from my '92 VFR750F. You can have it if you pay postage from Boise, Idaho. Otherwise it goes to the dump soon.
My gen3 petcock went TU and there are no new replacements to be found. I fabricated an adapter and installed an aftermarket petcock. It gives me...
Can you provide a data sheet? Typically for a 12V system the LEDs come three connected in series. You want to limit the current to about 250mA
The key is to use just enough to shine up the rubber without leaving an obvious film. Rub it in well and it should work just fine. BTW I don't run...
Going to the half mark is pretty good. I replaced my thermostat with a factory new one and it still runs a bit on the cold side. As long as your...
Check out this guide: 750 91 - 97 Carb Balance Guide Its on the vfrworld site. ;
Took my '92 out for a spin in Boise last evening. Temp was cool in the 40's F. A warm engine and cool intake air sure makes a good combo. The bike...
As you mentioned in a previous post, its like having a second job. It will be worth it however. You'll know your bike inside and out and you will...
Check the height of the fork tubes in the triple clamp as well. Raising the fork tubes in the triple clamp changes the rake angle and will make...
Doesn't sound particularly bad to me. The whine is the sound of the gear driven valve train which is classic for these engines. Also, it looks...
Separate names with a comma.