looks fantastic !! I like it.
bit of progress, I've been tied up on other things (selling off some bikes, 4 gone now). Here you see the missing section for the mirror has been...
Here the repairs start on the body. After 5 minutes you can cut the polyall200 & glass matt with craft knife. After 10-15 minutes you can hit it...
Thanks very much !
still have to run the bike again and check the Voltage Reg/Rec (notoriously shite on the 80's Hondas). I started the plastic welding on the seat...
[ATTACH] [ATTACH] ITS ALIVE !! Today was a good day. I finally got the last of the parts onto the bike (Carbs, Coils etc) and after swapping...
Thanks, will do. Will try to get around to installing the carbs this weekend, they're just sitting in there just now.
looks nice and warm where you guys are, im still neck deep in snow, im still months away from riding :( pic was taken this week [ATTACH]
a few more poorly focused pictures - need a new camera, my auto focus is F'd. The Hindle 4-1 went on with no issues at all, and ive picked the...
Agree with Jeremyr62, pull the carbs and learn how to clean them. There is no way to deal with your problems without tanking them apart. also...
Hindle 4-1 exhaust is cleaned up, re-painted the headers, re finished the end can, and installed it on the bike today. Carbs are being installed...
Needle & Seat or float issue. if the carbs are out its very simple to remove the float bowls and at a minimum clean the jets and change the...
thanks for all the replies guys !! very helpful Problem is now sorted - swapped out the left calliper again, all good !!
swapped the left calliper again (3rd different one) and different bleed screw and Im starting to get some pressure now.
Yes, the master is good, rock hard with finger over the hole, I tested it when I swapped it out. its rock hard with the line pinched at the left...
Separate names with a comma.
