Had you tried just two pistons on rear before linking all three? Still looking to try all three instead on just the two outer using F4i rear m/c,...
Though no experience with your bike, installation of helibars on my 6gen was not that complicated, good diy project. I would assume if they made...
Already had the side of the road down soon after getting bike, melted fuse holder under seat, grounds failing at connectors after installing...
[ATTACH] The F4i m/c makes a big difference but I’ve only got two pistons going until I can get a short banjo line to bridge all three, or the...
Thanks guys, had already ordered a F4i rear m/c before seeing this about cbr250rr. I assume push rod that may need cutting is the threaded portion...
I listen to music thru earphones and found the stock, then taller didn’t help the buffeting sound, added Givi 6” extension and if it was 3-4”...
Mine is 2002 that had a recall to replace wiring harness due to inadequate grounds at connectors, something like that, but I had already ran into...
I just looked at F4i rear master cylinder sets on eBay and it only has a one piston caliper, will this improve brake feel over my stock(14mm vs...
[ATTACH] No offense taken, if I was smart I’d be worried about my safety too! And you’re right, I didn’t even consider delink until looking at...
I just tested with all 6 pistons connected on front, used 5” braided line for now to link main line to center piston, stock master cylinder, two...
The two inside clips I destroyed getting out, replaced with auto door clip that fit perfect and tight. With new chain slider, sprockets, GXW...
In middle of chain and sprocket job, had same issue, I have a parts manual if you need Honda part number. I also found my chain slider was GONE!...
I found a Galfer Braided lines set for the vfr at half price, had bike since new And hadn’t thought about replacing lines until recently friends...
Found the problem, replaced tires, rotors and pads 8 months ago and thought the chain had less miles than it turns out, that and the chain slider...
Going for it, have removed all linked lines and will first try all six pistons on front and two outer on rear( until I find where to drill or get...
Separate names with a comma.