I knew all of that need to know what over sized piston will work so i can tare it down bore it hone it and put it back together like will the...
I would take it off of both ends and turn it by hand and see if other end is turning.it might be broke on inside.
no a mechanic didn't tell me I called places like weisco J E pistons and LA sleeves I know the 86/87 vfr700f1 had same piston diameter just don't...
Oh i know it is an issue yes the cams are in the right spot i double checked that. just need to know if there is another piston that can be...
OK knowing what the problem is can anyone tell me what other piston will fit in this motor so i can re tare down and rebuild this. have to much...
does it look like someone has tried prying the cap off? check to see if the clasps go into the tank on tank is bent and look at top ware the...
try pacyclesalvage.com or cyclesalvage.net hope this helps.
yes I oiled the piston and new rings as well as the cylinder walls as for the hone job a hand held honing device was used as with anything you...
The cdi box w/red plug in controls fuel pump and spark on left side of motor you can see if those are good by putting small wire in connector and...
OK ware do i find gadget that goes in spark plug hole so i can hook up air compressor to do test? I did check valves while waiting for parts took...
will try to do that I could see 1 bad cylinder but 2 even if those two cylinders were tapered putting new rings in them will not help because if...
test was performed cold and #s are L/f 82 L/r 55 r/f 148 r/r 125 and threw them in and called it good because I could not find over sized piston...
start to almost finished.
almost ready to paint.
1st brought home.
compression well below specs valves i checked while waiting for parts they are fine did find some high spots after honing must need to be...
hello everybody newbie here OK I have A 1985 vf700f interceptor just recently had cylinders honed and put in new rings my question is how long...
Separate names with a comma.
