Were the carbs clogged up? If so then you need to pull the pilot jets to clean the cross-drilled holes in the emulsion tubes, same for the main...
There should not be continuity between the 3 wires on the RR side, if there is then the RR is shorted internally.
i think you better re-take Cleaning Carbs 101 and take the exam again... http://vfrworld.com/forums/showthread.php/22449-Cleaning-carbs Get a...
Don't ever separate the carbs from the plenum plate just for cleaning--nothing good will come of it.
That was good advice to clean the pilot screw, but they forgot about the passage from the pilot jet TO the pilot screw. When it was running on...
It sounds like your idle circuit is clogged, and possible the choke circuit. Have you seen the thread on this site about 'cleaning carbs' do a...
Seems like that is an error in the manual, the larger jets go in the rear cylinders since they run hotter. Here is discussion for the VF500...
what size pilot jets were in the "kit"? What has been done to the engine or cams/valvetrain/intake manifold/exhaust to require such a large jump...
i hope the new clutch disks cure the problem. Earlier you said: When the engagement is so far out on the lever it indicates to me a fluid...
And tip-over on the little kid when he goes to get his toys or bike--too scary for even this southern redneck squid especially when kids are...
Gotta love that 2nd Gen--best vfr ever
The pressure plate is being held 'open' by the fluid pressure in the line pushing against the slave piston and push rod--that's why the clutch is...
The crud in the return orifice is in the master cylinder, not the slave. It is a tiny port located under (sometimes) a shiny metal plate visible...
Howdy Lovie, a couple of things you could try before pulling the carbs, 1 open the screw and drain the carb bowl and catch the contents to...
Well just being the stubborn squidbillie redneck that i am, i had to go an try to ride with no-hands to see if i could make it happen too. So...
my first guess would be low tire pressure from sitting in old tires--if it happened to me i would probably check the pressure and adjust, then try...
Those ST carbs look like more pain to remove and insert than ours--glad we don't have to deal with all that mess...
cleaning carbs http://vfrworld.com/forums/showthread.php/22449-Cleaning-carbs pictures...
A little confusing, maybe it's the RR at fault? The resistance measurement of stator to ground appears to show a short to ground in the stator,...
Howdy Squirrel and Rider, macdaddy's carbs are leaking fuel and he sent me an email asking about interchange--wants to buy a ready-to-go set off...
Separate names with a comma.
