Use a liquid. The powders tend to "scratch" things a bit and can take the color off leather. Use less than you think you need to start with and...
There is another new one for the 500 on Ebay right now:...
Way back when I did the swap, that was all I could come up with. I'm looking at a set of 17s (or a matching rear for my CBR front) and maybe a...
I'll take some pics and it is the Hondaline unit. It matches the lines of the tail section. I'll also get some dimensions off it for you, should...
I still have the one for my 1000, think it would fit without too much work? It has some chips in the coating. I won't be putting it back on, it's...
They would need to be able to prove that the "modification" caused a failure. And if you were unsure, just change it back to stock before bringing...
Hi Tom, what front end are you running on your 1000R? I'm thinking of updating my 1000F. I just don't like watching my forks flex quite so much!...
Pull the clutch slave off and then pull the pushrod out and see if there's a groove worn into it. If there isn't, it's probably in the plates or...
What I've seen at the track is when the output shaft is rigidly connected to the rear wheel like that (no rubber dampers), the shock from hard up...
How will you be connecting the tranny output shaft to the MG rearend? It's going to need some rubber damping to keep the teeth on the tranny gears.
40 negatives in the last month alone=not a good vendor. I would think twice before buying from him.
Run 0psi and change your fork fluid to some real fork oil, not the atf stuff that came in it. And that leads to the next question, has it ever...
I did and here's what Monty wrote: <Doug, Hi. I just tried to update myself on your Honda. In the past few years I started selling on...
Gonna need pics when you're done. I raced an '89 for quite a while. 145rwhp, 360lbs with 1/2 tank of fuel. Many mods done to lighten it up. I ran...
There's a guy in the UK who has an FF he's parting out. He has the whole rear wheel, which looks like the R Comstar, you'll have to take a look to...
I don't have an extra one, but I should see if my dad is really going to rebuild his (a car pulled out in front of him about 15yrs ago and it's...
EBC from Bikebandit.com $134.00 ea. http://www.bikebandit.com/aftermarket-parts-list?d=1170244+1202994+2403808+2404573
Stiffer springs and change to a heavier weight fluid, but no air pressure and that should take care of it. Seals will last longer that way.
Better to just use a battery tender, as the charging system won't do anything noticable until about 2000 rpm. And then you'd have to let it run...
Separate names with a comma.
