[IMG] Old fuel pipes cleaned up, with new o-rings about to go on. [IMG] New lines attached, ready to go on. [IMG] Almost there. Plenum ready...
Is that using paper, to gap the butterfly valves? Sent from my iPhone using Tapatalk
All done. All 4 carbs cleaned and today I’ve installed the E10 compatible fuel lines and o rings from V4 dreams. Took my time and it went ok. Only...
Found it. [emoji108] [IMG] Sent from my iPhone using Tapatalk
It was going so well; I’ve spent the day stripping down the carbs, one by one. Pretty certain someone has had these off in the past as the...
[IMG] Failing to plan is planning to fail. Getting my head around what gaskets I have and haven’t got, ready to get this motor running, next...
Had a go at the electrolysis method of cleaning the tank, with some success. Managed to remove some more rust particles from inside. I now need to...
So as I’ve got the carbs and tank off, as well as replacing the coolant seals, I suppose I might as well check valve clearances. Do I need this...
A touch frustrating today. I have two packages of parts at the post office, which were meant to be delivered today, but weren’t. So a few minor...
I’ve got to the point in this project where I seem to be spending a lot of cash, yet I haven’t actually fixed anything on the bike! Hopefully that...
Ok, think I have worked it out. So I’ve ordered 2 seals for the cross pipe and also ordered seals numbered 17 and 18. I take it that I have to...
So I can see you’re talking about part 15 for the cross tube O rings. The 2 under the caps, do you mean part 18 in the diagram? Sent from my...
Thank you! Sent from my iPhone using Tapatalk
I’ve had a quick look in the service manual and can’t see a reference to the o rings in there. Is there anywhere that has how to do this written...
Then went to an autofactors shop to buy some fuel hose. Of course I’ve bought the wrong diameter. Lesson learnt, so I’ve bought the right stuff...
Another two steps forward, one step back, kind of day. Started off by spending an hour or so wiping down the engine block, wiring looms and some...
While I’m waiting for the parts to arrive from Joe at V4 dreams, I’m going to spend today trying to clean the chassis, sub-frames and components...
That was @RogueRC24 top tip. Thanks for all your help everyone. Feeling a bit more confident about it. [emoji106] Sent from my iPhone using Tapatalk
A pretty rubbish day a work, so a bit of therapy by starting the process of cleaning up the outside of the carb bodies. Quite a nice way to switch...
Ok, a couple of emails to Joe at V4 dreams and I’ve got the fuel pipes and o-rings on order, ready to start the refurb.
Separate names with a comma.
