yeah, their web site is a bit to navigate - takes getting used to but they have a bunch of hard to find parts. They do have an ebay store but...
I've ordered a bunch of gaskets for my FZR, ZX7 and VFR from siriusconinc dot com. good customer service and no problems with the product. The...
I looked high and low for a replacement exhaust for m 93 for a while. I went with a Delkevic headers as my stock set had seen better days. then...
San fran bay area. not sure if this person knows what they have but a solo seat cowl (with stock windshield) for $50? Looks to be in great...
The 6th gen mirrors have different spacing for the bolts than the 5th gen. 5th gen has the same spacing as 3rd and 4th. I ended up ordering the...
If you give me a few days and i can actually get a chance to get into my garage, I will look for my 3rd gen center stand. If all the parts are...
oops, my mistake. I thought it was the CBR with the 3 wires. I have to pay more attention and drink less IPA
I think there may also be a wire that goes to the tilt sensor. kills then engine when bike goes over. It's either connected to the ignition or...
yes, I thought about the down and left. it has to clear the swing arm anyway, so thought with some fudging, it wouldn't be bad. The other...
Funny, I was planning the same thing. I have 2 spare headers for the gen 3. I was going to see if cutting off the end of the chamber and...
yes, a 4th gen header and down pipes will fit on a 3rd gen. I don't think there's any major mods to be done. The only thing is you lose the...
I'm now down to 5 bikes, 3 vfrs. I've been a huge V4 fan from the day they first showed up. I used to buy the bike that I really wanted to...
With that info, I'd say definitely the 98 - assuming the cosmetics are not an issue. And having dropped many a bikes in the driveway myself, I'd...
I had to go 6 years without a ride due to severe economic reasons. Worst 6 years of my life. On the flip side, when I finally got back on a...
If you're not making progress and it helps, I'd be willing to take it off your hands for the $550 you paid and whatever parts from me, you ended...
I have a straight gen 3 front wheel - no rotors, a gen 4 front wheel - no rotors. A gen 4 straight sub frame. Gen 4 gas tank with a dent,...
I definitely like this thread... So I've always wanted a metal lathe but the cost to use ratio was too high, as you have hinted at. I never...
I'm with Rollin. It's a lot easier than you would think. Learn to do your own tires, saves on all the headaches you might run into with some of...
If it's on the internet, it HAS to be true. Those are the rules. Having established that, the next question becomes, will the new bike be as...
i dont think theres an easy swap that keeps the original front wheel. usually takes some machining for spacer or axle issues. cbr 929 or 954...
Separate names with a comma.
