Looking to do my first shim under bucket type valve adjustment. Does anyone have a recommendation on a micrometer that will do a good job for a...
I just did a quick search. Seems to be available on this side of the border.
You can get the rim repaired if you can't find one.
so the bike starts and runs every time but it is just the clock resetting is the problem?
I believe the rubberized ones are for noise reduction.
bad diaphragms?
I believe that if you don't have the cowl on, the slots are just open. That's the way it is on my bike anyway.
I installed a SS clutch line. I wanted a little better feel.
Just be careful. A lot of power for a new rider.
Did you adjust the float levels after replace the float valves?
I can vouch for the heaviness. Mine went all the way down a few months back and I had to use some ratcheting tie downs to raise it back up. I'm...
I would stick with the recommended weight. Tolerances are so close in modern engines that a thicker oil might not have enough oil flow. Back in...
I always use EBC HH pads but not because they stop better or worse, just because my bike stays a little cleaner (less brake dust).
I did. It makes the side stand too long. Still usable but I put on an aftermarket one. The centerstand is very hard to use. Handling wise I...
I'm short too. Lowering links help.
Thanks. I was afraid of that. Sounds like a big job. Maybe I will get lucky and all the valves will be within specs.
Check and clean the grounds and check the position of the kill switch.
I bought mine used with 31k miles on it and I am thinking I need to adjust mine. Running fine but who know if and when this was ever done? Are...
None of the above. Aluminum alloy.
I get about 10k rear and an additional 2-3k on the front on my PR4 tires. Mostly fairly tame commuting miles though. Mileage varies widely based...
Separate names with a comma.
