to perform this job, you will need: 1/4" ratchet (1/2" is optional) torque wrench extensions 8 & 10 mm sockets #2 phillips...
reconnect the banjo & fittings
they just push back on when you reinstall them
make sure the wire holder is in the correct location & torque the fuel pump assembly bolts to 120 in/lbs
shown installed correctly
if these little nubs are not pulled passed their little notch, they ARE NOT seated correctly
it has little nubs that hold it in place & then needs to be wrestled up & around the assembly
pull the lines off the old filter & install the new one
use #2 phillips it took quite a bit of force & I nearly stripped the screw
use needle nose or slip joint pliers
it took quite a bit of wrestling
use 1/4 ratchet & 10 mm socket
fuel filter & fuel pump assembly rubber gasket
torque the plugs to 108 in/lbs
a view down into the head
with the tank out of the way, you have a clear shot at the rear plugs
use either a 8 mm allen or socket
make sure it's secure & has some kind of padding beneath it
you need to pull the blue & white connectors
Separate names with a comma.
